Share this content on Facebook!
11 Jan 2016
Conventional Water Heaters
water heater installation lakeway

Hot water heaters have a long lifespan nevertheless they need to be replaced eventually. In terms of water heater installation is concerned, it is not a complex process with an experienced handyman and is easily completed in a short time of time. However, it is very important ensure that all the connections are made correctly and there are no errors.

Cruising you need to keep in mind when you're thinking of installing a brand new water heater on your own is that you might want the right tools to ensure that all of the connections are made in the best manner. You won't get too much without the right tools.

The first thing you need to do is to detach the current water heater. Before you start detaching, you should shut off all the connections such as water collection, gas connection or electrical connection based on the type of heater you've in your place. Keep in mind that water heaters are heavy and you must be prepared to handle the load to prevent it from falling down and cause injury.

Now, you should connect the hose for the drain valve in the old heater. This drain valve is situated near the bottom of the water heater. The hose should be placed outside. Isn't it about time to unscrew the Inlet in addition to outlet fittings. They are on the top of the heater and a pipe wrench will be needed for this. You will also must unscrew the gas line fitting.

In the end the connections have been disconnected, you can safely eliminate the old heater. You will need to dispose of the old heater as per the regulations and rules in your location. You can now safely squeeze new water heater rather than the old one and level it.

water heater service austin

You'll want to ensure that various controls of the heater are accessible in the position you are going to use it. Once heater is within place, you can connect the outlet as well as inlet pipe. Yet again, you will need a pipe wrench to screw the inlet and outlet pipes. Now you should open the lake line and allow the tank fill completely.

When the tank has been filled, it's time to connect the gas line with the aid of the pipe wrench or if you have chosen an electric heater, it's about time to switch on the mains. That is all there is to installation of water heater.

However, you should engage in this activity provided that you are sure about handling all of this. If you have any doubts or you are not good using the tools, you should hire the services of an expert technician to do the water heater installation at a reasonable cost.


Comments

There isn't any comment in this page yet!

Do you want to be the first commenter?


New Comment

Full Name:
E-Mail Address:
Your website (if exists):
Your Comment:
Security code: